1. The dump truck can not suddenly push the lifting handle to the descending position during the process of full-load and parallel lifting, because this will cause the dump truck to suddenly rush down, which will bring the frame to it. Big shocks may even cause an accident. Therefore, care should be taken to avoid any appeals. If there are some special situations, they need careful operation. You need to slow down the speed as much as possible, and you need to be careful not to drop the car to the low level. 2. The power take off device cannot be in the on position during the driving of the dump truck, because it will cause the oil pump to burn out. 3. Before the dump truck is driven, it is necessary to carefully check the locking devices. 4. During the driving process of the dump truck , no people can be carried in the carriage, and when loading and unloading the cargo, it is necessary to park the vehicle on the ground for operation. 5, vehicles can not be slammed and shoved to carry out unloading, if the rapid emergence of the car's relatively large inertia force, it will easily lead to the frame will be permanently deformed, the sub-frame and the car will appear open The condition of the weld. Or damage to the seal ring and the oil pump, as well as damage to hydraulic cylinders, etc. This use situation will greatly reduce the service life of the dump truck. In severe cases, it will cause a rollover accident. 6, when the dump truck in the unloading of the goods, you need to take off the power take off before driving, if not in accordance with the formal operation, that is caused by the oil temperature of the hydraulic oil will quickly rise, leading to the vehicle's oil pump seal There is damage, and there may be a case where the dump truck's oil pump burns. The most serious situation is that the oil pump operation represents the power source of the hydraulic system. Even if the vehicle is in the process of driving, there will be automatic car. Raised situation. 7. When the dump truck is in motion, it should be started slowly from the first gear. It is not allowed to use the clutch to control the speed of the car in a semi-integrated situation. 8. When the driver leaves the vehicle, it is necessary to tighten the hand brake gas. Timely cleaning and maintenance work for the vehicle. LED Strobe Beacon,Warning Beacon Light,LED Emergency Strobe Beacon,Safety Strobe Beacon Shaoxing Groupstar Electric Appliance Co., Ltd. , https://www.led-auto-lamps.com