CNC Plastic Machining & Turning ,Connecticut Plastics specializes in CNC plastic machining and turned components, precision plastic machining and plastic fabrication.For precision CNC plastic machining requirements, we have developed lathe tooling technology capable of delivering superior surface finishes and optical clarity. Our continuous upgrades on CNC equipment has allowed us to maintain our position as a premier CNC plastic fabricator.Our CNC plastic machining equipment can process a wide range of components from micro turning to 20 inches in diameter. Equipped with milling heads and subspindles, Connecticut Plastics` CNC lathes can produce many components complete with efficient cycle times. The best and most consistent CNC plastic components are produced without secondary operations such as deburring.Our CNC lathe capabilities include:General purpose and Swiss turning Cnc Plastic Parts,Rapid Plastic Part,Plastic Cnc Turning Machining Parts,Cnc Machining Plastic Parts Topwell Spring Development Ltd. , http://www.topwelldesign.com
The sensors of these instruments are high-quality photodiodes and are covered with high-sensitivity filters. The sensor converts the incident light into an electrical signal, producing a standard XYZ tristimulus value directly.
However, the fit of the colorimeter's sensor accuracy with the CIE curve is always limited, and some small error deviations will definitely exist on the sensitivity curve of the measurement instrument. These small errors can be ignored when measuring light sources that emit continuous energy over the entire visible spectrum. However, if the spectral line of the spectrum is very special or the bandwidth is very narrow, then the measurement may have a large error. Therefore, the three-filter colorimeter is generally not suitable for measuring spectral line special light sources, such as high-pressure discharge lamps (refer to Figure 3.2.3.5a), or light sources with very narrow spectral bandwidth, such as LEDs (refer to Figure 3.2. 3.5b). 
2, 4, 5, & 6 axis lathes
Prototype through long run quantities
Lights-out operation
Mill turn capabilities (Live mill tools with full C axis)
Programming via MasterCam
Plastic compatible coolants
Micro components to 20 inches in diameter
Length up to 12 inches
10 -16 micro inch finishes
Near Optical quality turning
Deep-hole drilling
Sanen Chi taught you how to use tristimulus color difference meter
Three instruments that use spectral sensitivity to match the CIE tristimulus color matching function curve to measure light source color are called tristimulus colorimeters, also called three-filter colorimeters. In addition to colorimetric measurements, these instruments often include one of four photometric measurements, such as brightness, illuminance, light intensity, or flux measurements.