Many customer faced the problem of X axis and Y axis not perpendicular, because of the screw lose, so I would like cheach you how to addjust the Y axis ceossbeam, make the X and Y axis all right.
Found the A B C D point of the machine, adjust the machine according to the steps below
Is it a yurt? Is it a tent? What exactly is a bell tent??? Great question. A bell tent may look like a yurt canvas bell tent,bell tents for glamping,cotton bell tent,camping bell tent,double door bell tent Ningbo Autrends International Trade Co., Ltd. , https://www.autrendstents.com
(if it`s like waaaay in the distance and you`re squinting), and it is indeed a type of tent, just not like
the kind of tent you see when scrolling through emojis. Simply put, a bell tent is a multipurpose
shelter with a single central pole and canvas exterior that is used for camping, outdoor, events,
and so much more.
The bell tent is a tent that has been in use since 600 AD for human habitation, travel, or leisure.
The design is a simple structure supported by a central pole covered with cotton canvas. The
stability of the tent is reinforced by tension through the ties attached around the top of the
walls and secured to the ground by pegs around the circumference.
We provide high-quality waterproof firm bell tents and many sizes to choose from.
At the same time, we also provide customized services, like logo print.
Adjust cutting table make X and Y axis perpendicular
A)please unfasten C mark screws
B)move Y axis E mark to X axis a little(please move according to test,you need to test and try a few times)
C)fasten the D,A,B mark screws.
Check the effect is good or not by below step:
Cut two squre board by our cutting machine
rotate one square 90 angle
put the two square together(one normal and one rotate 90 angle), if four side superposition,machine is ok.if only two side superposition,you need to adjust the machine again.
Contact me freely if you have any qustion about the process:
tel:
QQ:
E-mail:
Skype: trinityhu
ICQ:
Yahoo:
MSN: