In the process of work, suction pump vacuum pump usually appears to be a certain failure at the start, there are some damage, and in the process of operation, the vacuum is not very good, there may even be noise . Immediately afterwards, there were experts from the technical department and authoritative sources to analyze how the start-up failures were still not fully implemented and what the noise was. First of all, from the start of the suction truck vacuum pump. First of all, we must know that vacuum pumps for suction trucks often work in some wet environments. Therefore, the interior of vacuum pump containers often appears rusted or even corroded by acid. Therefore, in this case, the first step is to remove the rust from the suction pump vacuum pump. This step is very critical. Because if there is more and more rust inside the suction truck vacuum pump, then it will eventually lead to the accumulation of the inlet, as well as plugging and blocking of the outlet, and even the plugging of the outlet, so this will come The bigger it is. The second possibility, then we need to investigate whether there is a certain degree of wear and corrosion of the rotating sheet. If there are any problems and faults in the rotating plate, it needs to be adjusted and replaced in time, because the rotation speed of the rotating plate is also very critical, and it also plays a key role in the effect of vacuum. What needs to be examined below is that there are no faults or problems in the motor system inside the suction truck vacuum pump. If there is a short circuit or a short circuit in the motor system or an open circuit and insufficient voltage disturbance, as well as an unbalanced state, then the motor must be replaced in time and repaired and maintained. This is also based on the factory conditions. Explain the specified maintenance instructions for a certain repair. If none of the three mentioned above appears, then at this time it is necessary to check whether the outlet port is closed or if there is any blockage. If there is any foreign matter from the outlet, then this is a very serious problem for the suction truck vacuum pump. At this time, first of all, it is necessary to perform a very good treatment on the debris of the port and position the problem site so that the gas outlet can fully circulate gas. If there is damage to the rotating sheet, this will not only cause malfunctions and difficulties in starting the suction truck vacuum pump, but also cause some noise and noise during the operation. So for the suction pump vacuum pump itself, the rotor and the rotor are often very critical and the core system architecture must not show any wear and damage. Therefore, the above mentioned items are very important. The golden rule from experts in the technical department and authoritative people has played a very important influential factor in the process of using vacuum pumps for suction trucks. . Jiangsu Aoli New Materials Co.,Ltd , https://www.jsaolimaterials.com
