Mud pump failure 1: The pump is not absorbent Cause: Insufficient filling water, the pump air can not be discharged, the suction pipe leaks, the front liner and the impeller clearance big solution: continue perfusion water, check the pipeline is leaky, adjust the impeller and the front Liner gap mud pump failure 2: Pumping water is slow Cause: The front liner and the impeller gap, the outlet pipe can not seal the air, emptying over Solution: Adjust the gap, adjust the outlet pipe, install the vacuum device Mud pump failure 3 : The water pressure is small, the flow is small Reason: the pump air, the gap between the impeller and the front liner, the clutch is not closed, the impeller or liner wear Solution: empty the pump gas, adjust the gap, adjust the clutch friction plate clearance, Replace Impeller or Liner Mud Pump Fault 4: Pump Vibration Cause: The pump shaft is not the same as the diesel engine (or motor), the impeller is unbalanced and the bearing is damaged Solution: Adjust the concentricity and impeller for balance test, replace the bearing mud pump Fault 5: Impeller hub wear fast reason: high-pressure pump low head, packing root dislocation, the pump shaft and the back cover is not the heart Solution: Replace the pump head higher than the mud High pressure pump, replacement of packing, adjust the concentric mud pump failure 6: pump wear reason: poor construction environment (large particles), the transmission distance, the length of the inlet pipe Solution: change the battlefield, add the power unit, shorten the inlet pipe Cavitation decreases in length PHE Spare Plate For Thermowave Phe Plate For Thermove,Thermove Phe Plate,Plate Heat Exchangers,Phe Heat Exchangers Plates Dongguan Runfengda F&M Co., Ltd , https://www.runfengd.com