Some drivers use the anti-mine anti-explosion vehicle when the idling body will tremble, accelerate the vehicle speed is not fast, fuel consumption has suddenly increased. If any of these conditions occur, it means that the engine has more carbon deposits that need to be cleaned. Therefore, to reduce or effectively prevent the production of carbon deposits, it is necessary to reduce the idling speed of mining explosion-proof vehicles. The pistons of the mine explosion-proof vehicle engine are not synchronized. When the vehicle shuts down, the cylinder intake valves of the engine cannot all be closed at the same time, and the oil emitted during this working cycle cannot be recovered in time. Some unburned The fuel will continue to be vaporized and oxidized, producing some softer black carbon deposits in the intake pipe, especially behind the throttle. When the valves form a carbon deposit, each time fuel injected into the cylinder is absorbed, the concentration of the mixture that really enters the cylinder becomes lean, resulting in poor engine operation. When the vehicle is idling, the vehicle body trembles. When the vehicle accelerates, the speed of the explosion-proof vehicle is not fast. , Fuel consumption also suddenly increased and other anomalies. Some owners think that high-quality oil will have better quality. In fact, this is not entirely correct. The label only represents the octane number of the oil and does not represent quality and cleanliness. Mine explosion-proof cars to reduce carbon deposition, proper addition of diesel detergent will have a certain effect. "Dismantling the mine explosion-proof car engine is definitely the most direct method, but if the engine is dismantled because of too much carbon, it will inevitably affect the service life of the engine. It will not be worth the candle." Some owners are used to idling, and they will idling Reducing the flow of air into the engine, so that the erosion of carbon deposition is also very weak, it will promote the deposition of carbon deposits, therefore, to reduce the idle speed, multi-run high speed is a very good way, this is also people often say pull High-speed, high-speed pulling is the use of gas flow against the inlet scouring to prevent carbon deposition. In the process of using mine explosion-proof vehicles, idling is inevitable. However, in order to reduce the occurrence of explosion-proof cars in the future, it is best to reduce idling speed. Metal Rolling Shutter Doors Forming Machine
A rolling shutter door or roller shutter door is a type of door that consists of many horizontal slats hinge together and the door opens and closes by raising up or lowering down along a rolling shutter door track or guide rails.The rolling up door forming machine is automatic machine which can make different legnth as per your set.
The final product can be cut as per set length controller,and the length is automatically measured by encoder.When final product reached set length,machine will stop to cut the sheet automatically.Finish thhis action,the machine will run again continuously
Metal Rolling Shutter Doors Forming Machine,Door Slat Roll Forming Machine,Metal Door Frame Roll Forming Machine,0.8-1.2Mm Metal Thickness Botou Golden Integrity Roll Forming Machine Co.,Ltd , https://www.jcxsteelrollformer.com