Cobalt-based alloy powders are commonly used in laser cladding processes due to their excellent wear resistance, high temperature strength, and corrosion resistance. These alloys typically contain varying amounts of cobalt, chromium, tungsten, and nickel, among other elements, to achieve specific properties. Cobalt 12 Alloy Powder,Cobalt 21 Alloy Powder,Cobalt 6 Alloy Powder,Cobalt Laser Cladding Powder Luoyang Golden Egret Geotools Co., Ltd , https://www.xtchvof.com
Then, how does the frequency converter work on the leather mechanical slitter and complete its function? The following will be discussed in detail:
The working principle of the inverter in the system constant tension control The essence of the constant tension control in the retracting and unwinding process is to know the change of the winding diameter of the load during the operation, because the change causes the output torque of the motor to be maintained in order to maintain the operation of the load. Follow the changes in the diameter of the coil. Anbang letter frequency converter can do torque control, so it can also complete the constant tension control. Anbang letter frequency converter provides three analog input ports. The three-way analog input can be defined as a variety of functions, so one can be used as a torque reference and the other as a speed limit. For the slitter, the part of calculating the roll diameter is calculated by the tension controller. In other words, you can set the tension on the man-machine or text, calculate the roll diameter through the PLC, you can calculate the torque required to output the motor, through the analog output to the torque of the Ampang inverter given end can.
System debugging process and parameter setting 1. Parameter setting of Ampon Inverter (1) All parameters of the driver are adjusted to the factory value.
(2) Separate the motor shaft from the load.
(3) Set the motor rated voltage parameter setting 01-02, motor rated frequency parameter to 01-01.
(4) Set parameter 05-00 to 1 and press the KeypadRUN command.
(5) After the execution, check whether some of the parameters have been automatically filled in with the measured data.
2. Anbang letter converter closed-loop vector operation debugging will set the operation mode as panel start, the frequency given mode is given by the panel. Running mode is V/F+PG. Set the frequency to 10Hz, and then run. Observe whether the inverter will report the PG alarm. If the PG alarm is reported, set 10-01 to 1, and then turn off the power again. Press the Run button again to ensure that the inverter does not alarm. Press the Mode key at the same time to switch the display operating frequency. Observe whether the fluctuation occurs at 10Hz to ensure the commissioning is completed.
The laser cladding process involves melting the cobalt-based alloy powder using a high-energy laser beam and depositing it onto a substrate to form a protective coating. This coating helps to enhance the surface properties of the substrate, such as hardness, wear resistance, and corrosion resistance.
The successful application of An Bangxin converter in leather machinery slitting machine
It is understood that the application of the leather mechanical slitting machine to the inverter in practical work has become more and more common, because the inverter plays a very good auxiliary role in the equipment, such as the characteristics of the AC asynchronous motor is not good, the activation torque Low and non-linear Therefore, in the entire process of winding, the winding motor should be avoided below 2HZ to ensure that the winding motor has a minimum speed limit. Can also achieve the speed limit of the equipment to run and so on.