Datang Mobile - Cellular Internet of Things Technology Promotion Award

Large-scale antennas take full advantage of the vertical and horizontal dimensional freedom in 3D channels and have great advantages in terms of spectrum utilization efficiency and system capacity, and are therefore recognized as the key technologies in 5G eMBB scenarios.

In April 2016, Datang released the world's largest 256 large-scale antenna. The product uses high-end space multiplexing pilot transmission, channel status feedback and other programs to support the maximum 32-stream transmission; in the sending and receiving programs, multi-user pairing and scheduling mechanisms, put forward in the high efficiency and low complexity of innovation In addition, this product introduces a new design scheme in array structure design, integrated transceiver, high efficiency amplifier, antenna calibration, heat dissipation, etc. . Measured in the 3.5G band, the use of 100MHz bandwidth, 20 simultaneous data streams, the rate of 4Gbps, the industry leader.

In September of this year, Datang has completed all the tests of the first phase of the 5G technology test, including technical verification of large-scale antennas, non-orthogonal multiple access, and ultra-dense networking. For the large-scale antenna, the average performance of the system and the extreme performance of the user-distributed system are also tested on the basis of the peak rate, which fully verifies the use effect of the large-scale antenna in various environments.

Other Series Of Plate Heat Exchangers

Thermal hybrid design technology enables plates of the same specification to have a wider range of adaptability to working conditions. Two angle plates are used in the plate structure design to form three channels, realize five channel combinations, and ultimately achieve PHE energy-saving requirements. Through the heat transfer calculation software simulation with THT's independent intellectual property rights and the optimized combination of plate channels, the optimal selection of heat transfer performance and resistance is achieved, saving investment for customers.


The movable plate is equipped with a double roller bearing sliding mechanism, making the disassembly and assembly of the movable plate more flexible and faster.

The surface of the carbon steel frame is painted using advanced electrostatic spraying technology, combined with a high-temperature curing process to make the paint film stronger, have better adhesion, have stronger anti-corrosion properties, and be more environmentally friendly.

Advanced frame quick installation system, the front clamping nut is integrated with the screw through a locking bolt, and is equipped with a bearing box. The rear clamping nut is prevented from loosening by a unique locking sleeve. When disassembling and installing the equipment, you only need to tighten or loosen it. The front clamping nut is all it takes. Maintenance, disassembly and assembly are more convenient and faster, typical humanized design.


Other Series Of Plate Heat Exchangers,Other Series Of Brazed Plate Heat Exchanger,Other Series Of Plate Type Heat Exchanger,Plate And Shell Heat Exchanger

Siping Juyuan Hanyang Plate Heat Exchanger Co., Ltd , https://www.tj-heatexchange.com