The overheating of the engine of the bulk cement truck is very dangerous, and bad luck may cause the engine to be destroyed. When driving on highways at a high speed, or when climbing bulk cement trucks, if the pointer of the water temperature gauge enters the red zone, remains high, or repeatedly shakes in the red zone, emergency measures must be taken at this time. If the engine of a bulk cement truck is overheated on an ordinary highway, the speed should be reduced as quickly as possible, and the bulk cement truck should be driven into the shade or to a relatively cool place to stop the bulk cement truck. Open the engine cover and allow the engine to idle and wait for the engine temperature to gradually return to normal. After the engine water temperature returns to normal, the engine is turned off. Then wait for a period of time until the water temperature of the engine has sufficiently decreased, and then check the cooling water volume of the engine. At this time, the amount of cooling water in the engine is seriously insufficient. After replenishing the cooling water by the specified amount, check the cooling system again. After confirming that there are no other problems, start the engine and continue driving. If the bulk cement truck had an overheated engine on the expressway, the heater must be fully opened and the window should be opened immediately. At this time, the inside of the cabin would be hot like hell. Because there is warm air to help cool the cooling water, cooling water temperature can be greatly reduced. This can continue to drive, find the exit of the expressway nearby, and drive the bulk cement truck to a safe place to stop. Next, just follow the method described above to bring down the temperature of the engine. Note that it is best not to park bulk cement trucks on the roadside, so as not to affect traffic or crashes. The bulk cement trucks must be parked in a safe place. An inspection well mould is a type of mould used to create inspection wells, which are structures that allow access to underground pipes, cables, and other utilities for maintenance and repairs. The mould is placed in the ground and filled with concrete or other materials to create a durable and secure structure that can withstand the weight of vehicles and other heavy equipment. Inspection Well Mould,concrete culvert mould,concrete manhole mold,vertical manhole mold Taizhou Amitycare International Co.,Ltd. , https://www.tzamity.com