Auman's first two rear dump trucks have features such as convenient loading and unloading, high transport efficiency, and flexibility. The load of the first two and eight dump trucks is about 1 to 20 tons. Because the nature of the vehicles used is variable, the driving environment is different. If you do not pay attention to the operation of the vehicles, there is a great possibility that they may cause accidents. appear. Therefore, driving the Auman before the second and eighth dump trucks must master some of the correct operating procedures. 1. Before the first two rear-dump trucks of Auman need to start, it is necessary to realize that the operating rods for checking the lift of the lower body and the switch are all in the disconnected position, and it is also necessary to observe whether the road ahead in driving is unimpeded. If necessary, you can first whistle warning, start a file. Then, from the rearview mirror or from the rear window in the cab, it is not possible to hang the second gear or the third gear after observing and determining the good body. 2. The first two rear dump trucks of Auman are basically diesel engines used as power. After starting the vehicle, they can idle for a short time and wait for the water temperature to rise to 45 degrees Celsius when they start. 3. In the process of driving Auman before the second and eighth dump trucks, you can replace the appropriate party committee according to the current road conditions, need to avoid overloading the vehicle engine for a longer period of time, need to change the sound of the engine and The degree of swing of the body to further determine whether the transport material and the body can be abnormal. 4. The amount of material loaded in the Auman front two rear dump trucks needs to be controlled within the rated capacity. Because the dump truck is often driven at the construction site, it is not difficult to avoid encountering some poor road conditions. If the vehicle is overloaded at this time, it will cause early damage to the relevant components such as axles, steel plates, and a large number of vehicles. And it will also increase the inertia of the dump truck, resulting in the declining performance of the brake and eventually leading to the accident. 5. When loading and unloading the dump trucks at the construction site during the first two rear axles of Auman, taking into account the complex environment of the construction site, it is better to arrange one person to conduct the command at each reversing to avoid collision and rolling. ACCIDENT. 6. The first two rear dump trucks of Auman are not allowed to carry persons in the buckets, or the materials and people are loaded at the same time. The vehicles must not be allowed to get on or off at will during the driving process. If the vehicle body is damaged, it cannot Load loose material to avoid spillage during transit. 7. Wait for the front and back of the dump truck driver to stop the vehicle and brake before loading materials. The buckets and buckets raised during the loading process must not cross over the top of the cab of the dump truck, and the safety of on-site construction workers must be better protected. In the process of pouring the material should be smooth and soft, as close as possible to the body. If you need to load more than 1T of rock, you need to use a crane for lifting, stacking should be uniform, if necessary, need to do a good job of fixing, to avoid rolling or partial loading of the stone caused by vehicle rollover accident. Hip Loop,Glute Loops,The Glute Loop,Hip Thruster Loop nantong pinli fitness co.,ltd , https://www.ntcnpinlifitness.com